GW Instek PEL-3111 - Page 163

FUNCTION MENU
161
 BATT No.
 Memo
 Mode
 Range
 Setting
 SlewRate=
 SlewRate?
 Stop Volt
 Stop Time
 Stop AH
 Datalog timer

3. Press the Save[F3] to save the selected test
setup.
Start BATT
4. Press BATT[F1] to turn the BATT function on if
it is off.
5. The BATT function can be started by turning
the load on by pressing
Shift Load
On/
Off
.
 The discharge test will keep running with its
defined mode and values until any of the Stop
Voltage, Stop Time or Stop AH settings is
detected.