GW Instek PEL-3111 - Page 21

GETTING STARTED
19
IMON Out
I MON OUT
Current monitor BNC terminal:
Output connector used to monitor
the current by outputting a
voltage. An output voltage of 1V
(10V for PEL-3000H) corresponds
to the full scale current for the H
and L ranges. 0.1V (1V for PEL-
3000H) corresponds to the full
scale current in the M range.
VMON Out
V MON OUT
Voltage monitor BNC terminal:
Output connector used to monitor
the voltage by outputting a
voltage. An output voltage of 8V
corresponds to the full scale
voltage.
TRIG OUT
TRIG OUT
Trigger out BNC terminal:
Outputs a pulse signal during
sequence or dynamic operation.
The trigger signal has a 4.5V
output with a pulse width of a
least 2us and an impedance of
500Ω.
LINK/STBY
Indicator
(PEL-3211(H))
LINK STBY
The LINK and STBY indicators
indicate when the booster pack is
properly connected and when the
power has been turned on,
respectively.