Max.Value:0.25 mg/L
Date:04/01/16 22:45
Min.Value:0.00 mg/L
Date:04/01/03 00:16
Clear Max. Value
Clear Min. Value
Max. Rec:5.00 mg/L
Min. Rec:0.00 mg/L
MEASURE SETTINGS
Select “Chlorine Menu” - “Measure Settings” and set the “Period” between 3 and 90 minutes.
Period (sampling rate) is the elapsed time between two consecutive chlorine measurements. The
sampling rate is also important when the analyzer is used for chlorine dosing. For larger pools, the
period must be longer, and for smaller pools, the period must be shorter.
The sampling rate can be quickly consulted on one chlorine measuring panel.
MEASURE INFO
The analyzer calculates the maximum and minimum concentration value since the first measurement.
The maximum and minimum can be quickly consulted on chlorine measuring panel.
To see information about these values, select “Chlorine Menu” - “Measure Info”. The time stamp
when maximum and minimum appears are also displayed in this menu.
To reset the maximum or minimum values, select the functions “Chlorine Menu”- “Measure Info” -
“Clear Max. Value”or “Chlorine Menu”- “Measure Info” - “Clear Min. Value”.
The maximum or minimum value will be set to the current read value.
ANALOG OUTPUT
The type of analog output can be set as described in “Analog output” chapter. The analog output
span for chlorine could be set in “Chlorine Menu” - “Analog Output Cl”.
“Min. Rec”will set the recorder lower limit and “Max. Rec” will set the recorder higher limit.
The Max. Rec. value must be greater than Min. Rec. value.
CHLORINE SETTINGS
40
To Next Page
Loading...
Need help?
General
