AMX RoomBook Scheduling Touch Panels
13
AMX RoomBook Scheduling Touch Panels - Instruction Manual
Accessing the SETTINGS Window
Scheduler Settings and Advanced Settings are both accessed via the SETTINGS window on the Acendo Book panel.
To invoke the SETTINGS window, use a paper-clip or similar tool to press and hold the recessed Settings pushbutton located on the
top edge of the panel (left side - see FIG. 4) for 5 seconds.
Alternatively, A long press of the room name (5 seconds minimum), will also invoke the SETTINGS window.
Acendo Book touch panels have two sets of configuration options: Scheduler Settings, and Advanced Settings:
NOTE: Scheduler Settings and Advanced Settings are both password-protected. The default Administrator password is "1988". The
Administrator password can be changed via options in the Security Setup page - see Changing the Administrator Password on the
Panel on page 33 for details.
Conf iguring Scheduler Settings
While the initial configuration for Acendo Book panels is managed via the Scheduling Panel Setup Wizard (FIG. 3 on page 12), most
of the settings made in the Scheduling Panel Setup Wizard can be edited via the Scheduler Settings pages.
Press SCHEDULER SETTINGS in the SETTINGS window to open the Scheduler Settings pages. Refer to the Scheduler
Settings section on page 35 for details.
Conf iguring Touch Panel Settings
ADVANCED SETTINGS are used to configure settings for the touch panel itself. Touch panel-specific settings can be viewed and
edited via the ADVANCED SETTINGS option.
Press ADVANCED SETTINGS in the SETTINGS window, and enter the Administrator password to access the panel’s on-board
Settings menu. Refer to the Advanced Settings section on page 42 for information on viewing/edit touch panel-specific options.
Powering Off the Panel
Note that the SETTINGS window also provides the option to gracefully power down the touch panel.
Press POWER OFF to power down the panel.
Cleaning the Touch Panel
When cleaning the device, do not directly spray the device with cleaning fluid. Instead, spray the cloth and then apply the cloth to
the touch screen.
CAUTION:
Do NOT use abrasives of any type to clean the device, as abrasives may permanently damage or remove the device’s
finish.
FIG. 4
Pushbutton - Located on the top edge of the panel (left side)
FIG. 5 SETTINGS window
Recessed pushbutton
located here
Press and hold for
5 seconds to access
the SETTINGS window
press and hold the Room Name
title bar for 5 seconds to access
the SETTINGS window
Alternatively,
Press to close the SETTINGS window
Press to access the panel’s on-board
Settings menu (Administrator password
Press to access the
Scheduler Settings pages
Press to power the panel off
required - default = 1988)
To Next Page
Loading...