Acendo BookInstallation
15
AMX RoomBook Scheduling Touch Panels - Instruction Manual
Installation Recommendations
During any installation, a lack of ventilation may produce conditions that may adversely affect the device’s operation. In these
circumstances, special care must be made to make sure that temperatures within enclosed areas do not exceed the device’s
maximum rated temperature.
NOTE: While the outside temperature of the device may be at or below its maximum operating temperature, special care must be
taken before and during installation to ensure that the maximum operating temperature is not exceeded within wall or rack
installation spaces.
Mounting Options
AMX RoomBook Scheduling Touch Panels can be installed via several mounting options:
Use the included clear plastic Backbox to attach the panel to most standard wall materials.
Other optional AMX mounting solutions include the MSA-MMK2-07/10 Multi Mount Kits, and the MSA-AMK2-07/10 Any Mount
Kits, and CB-MXSA-07/10 Rough-In Boxes. Refer to the Quick Start Guide included with each mounting kit for instructions.
Power Over Ethernet
Power for AMX RoomBook Scheduling Touch Panels is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified PoE
injector such as the PS-POE-AF-TC PoE Injector (FG423-83). The incoming Ethernet cable should be connected to the RJ-45 port
on the RMBK-701/1001.
Plastic Backbox
AMX RoomBook Scheduling Touch Panels come with a clear plastic Backbox. This Backbox can be used to mount the touch panel
into most standard wall materials. The Backbox can also used to mount the panel into other mounting options.
FIG. 8 RMBK-1001 Backbox (Front View)
FIG. 9 RMBK-701 Backbox (Front View)
Locking Tab (X4)
Locking Tab screw (x4)
Mounting holes (X4) for installing the Backbox into a Rough-In Box (screws not included)
Mounting holes (X4) for use with
Use these mounting holes to install
Locking Tab (X4)
Locking Tab screw (x4)
mounting screws (not included)
the Backbox into thin walls (less
than 0.5” thick) or solid surfaces
Locking Tab (X2)
Locking Tab screw (x2)
Mounting holes (X4) for use with
Use these mounting holes to install
mounting screws (not included)
the Backbox into thin walls (less
than 0.5” thick) or solid surfaces
Mounting holes (X2) for installing the Backbox
into a Rough-In Box (screws not included)
To Next Page
Loading...