Harman RMBK-1001 - Setting Static IP Information; Entering a New Hostname

Advanced Settings
50
AMX RoomBook Scheduling Touch Panels - Instruction Manual
Setting Static IP Information
When using DHCP settings for a panel, the DHCP server will automatically populate almost all of the Ethernet page fields, with the
exception of Hostname. When setting the panel for Static, however, this information must be entered manually. To enter the
network connection information:
1. Press DHCP/Static to access the DHCP/Static options window (FIG. 82):
To return to the Ethernet page without making any changes, press Cancel (or press outside the DHCP/Static window).
2. Press Static to select to use Static IP information, and open the Static IP window (FIG. 83).
3. Press any field in this window to open the on-screen keypad.
4. Enter the information for each field presented.
If the field accepts alphanumeric characters, a keyboard opens instead.
Press Next (in the on-screen keypad) to proceed to the next field.
5. When complete, press OK to save changes and return to the Static IP window. The new connection information is presented in
the Ethernet page.
To return to the Ethernet page without making any changes, press Cancel (or press outside the Static IP window).
Entering a New Hostname
In order to facilitate DNS lookup of the panel, you should set a new hostname for the panel.
To add a new hostname, or to change an existing one:
1. From the Ethernet page, select Hostname to open the Hostname window (FIG. 84).
2. Enter the new hostname and press OK. The new hostname will now appear in the Hostname field.
To return to the Ethernet page without making any changes, press Cancel (or press outside the Hostname window).
FIG. 82
DHCP/Static window
FIG. 83 Static IP window
FIG. 84 Hostname window