Configuration
CANHEAD A01185_11_X00_00 HBM: public 27
6.3 Base module CB1010
Fig. 6.5 Base module (CB1010) with amplifier module (CA1030)
The CB1010 base module (for strain‐gage half and full bridges and DC voltage
sources) enables strain gage bridges or transducers to be connected through
shielded RJ45 connection sockets.
There is no separate temperature compensation channel or any equipment for
bridge detuning through a shunt resistor, since these are not required for the
types of strain gage or transducer circuits used here.
To Next Page
Loading...
