Configuration
26 A01185_11_X00_00 HBM: public CANHEAD
At the time of delivery the CANHEAD system works with the internal shunt; the
jumper is plugged on. When an external shunt is used, the ”internal shunt” con
nector (see above) must be removed. An external shunt is not included in the
scope of supply.
6.2 Base module CB1016
The CB1016 base modul has been designed for 10 strain‐gage quarter bridges
in for‐wire configuration. The strain gage bridges are connected via shielded
RJ45 connector sockets.
As with every base module in four‐wire configuration, a shunt resistor has been
integrated.
To Next Page
Loading...
