Field of application
12 A01185_11_X00_00 HBM: public CANHEAD
4 Field of application
The CANHEAD system is 10‐channel measurement electronics for quar
ter‐bridge, half‐bridge, and full‐bridge strain gages, DC voltage sources and
strain gage‐based transducers.
The special feature of HBM's CANHEAD concept is the separate assembly of
the base module and the plug‐in amplifier module.
S Base module
S for wiring the SG or transducer connection cables
Base modules for SG‐quarterbridges (CB1014, CB1015) are available for all
the standard SG resistance values (120, 350, 700, 1000
S Amplifier module
S for implementing highly‐sensitive and precise measurements
So when installing the strain gages ‐ for example, in experimental stress analy
sis ‐ the base module (with all the wiring) is connected to the strain gages first.
This allows the the amplifier module to be used for other measuring tests until
its ultimate involvement. It is also possible to remove the amplifier module with
out the intelligent base module losing the measuring point specific data that
has been saved.
To Next Page
Loading...
