Safety instructions
6 A01185_11_X00_00 HBM: public CANHEAD
S Place the device so that it can easily be disconnected from the mains at any
time.
S The CANHEAD system can be safely operated up to a height of 2000 m
General dangers of failing to follow the safety instructions
The device is a state of the art unit and as such is reliable. The module may
give rise to dangers if it is inappropriately installed and operated by untrained
personnel.
Any person instructed to carry out installation, starting up, maintenance or
repair of the module must have read and understood the Operating Manual
and in particular the technical safety instructions.
Maintenance and cleaning
The CANHEAD system is maintenance‐free.
S Before cleaning, disconnect the equipment completely.
S Clean the housing with a soft, slightly damp (not wet!) cloth. Never use
solvents, since these could damage the labelling on the front panel and the
display.
S When cleaning, ensure that no liquid gets into the equipment or connec
tions.
Residual dangers
The scope of supply and performance of the CANHEAD system only covers a
small area of measurement technology. In addition, equipment planners,
installers and operators should plan, implement and respond to the safety
engineering considerations of measurement technology in such a way as to
minimize remaining dangers. On-site regulations must be complied with at all
times. There must be reference to the remaining dangers connected with
measurement technology.
Safety rules
The supply connection, as well as the signal and sense leads, must be
installed in such a way that electromagnetic interference does not adversely
To Next Page
Loading...
