HBM PX455 - Replacing Measurement and Communication Cards

Mounting/Dismounting/Replacing
50 A4354-2.2 HBM: public PMX
Dimensions and mounting instructions
215
152
138
200
122
min. 25*)
*) Min. dimension: Plug plus sensor cable
NOTE:
To ensure sufficient ventilation/cooling, a 2 cm
gap must be maintained above and below
neighboring devices.
7.4 Replacing measurement and
communication cards
Measurement and communication cards can be
retrofitted or removed at a later date. Please note the
combination options (see chapter 8.2.1 on page 55).
After modification and switching on the supply voltage,
the PMX automatically detects and initializes the
hardware configuration. The factory settings are loaded.
All parameters must be reentered, also for the existing
cards.