EasyManuals Logo

HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING User Manual

HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #280 background imageLoading...
Page #280 background image
280 Programming: Q Parameters
9.9 String Parameters
Converting a numerical value to a string
parameter
With the TOCHAR function, the TNC converts a numerical value to a
string parameter. This enables you to chain numerical values with
string variables.
U Select Q parameter functions
U Select the STRING FORMULA function
U Select the function for converting a numerical value to
a string parameter
U Enter the number or the desired Q parameter to be
converted, and confirm with the ENT key
U If desired, enter the number of decimal places that the
TNC should convert, and confirm with the ENT key
U Close the parenthetical expression with the ENT key
and confirm your entry with the END key.
Example: Convert parameter Q50 to string parameter QS11, use
3 decimal places
N37 QS11 = TOCHAR ( DAT+Q50 DECIMALS3 )

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING and is the answer not in the manual?

HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING Specifications

General IconGeneral
BrandHEIDENHAIN
ModelITNC 530 - 6-2010 DIN-ISO PROGRAMMING
CategoryControl Panel
LanguageEnglish

Related product manuals