TNC Model, Software and Features
HEIDENHAIN iTNC 530 11
Intended place of operation
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information
This product uses open source software. Further information is
available on the control under
U Programming and Editing operating mode
U MOD function
U LEGAL INFORMATION soft key
smarT.NC: Preview of contour
programs in the file manager
smarT.NC Pilot
smarT.NC: Positioning strategy for
machining point patterns
smarT.NC Pilot
FCL 2 functions Description
3-D line graphics Page 138
Virtual tool axis Page 498
USB support of block devices (memory
sticks, hard disks, CD-ROM drives)
Page 118
Possibility of assigning different depths
to each subcontour in the contour
formula
User’s Manual for
Cycles
Touch-probe cycle for global setting of
touch-probe parameters
User’s Manual for
Touch Probe Cycles
smarT.NC: Graphic support of block
scan
smarT.NC Pilot
smarT.NC: Coordinate transformation smarT.NC Pilot
smarT.NC: PLANE function smarT.NC Pilot
FCL 3 functions Description
To Next Page
Loading...
