386 Programming: Multiple Axis Machining
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1)
Reset the PLANE function
U Show the soft-key row with special functions
U Select special TNC functions: Press the SPECIAL TNC
FUNCTIONS soft key
U Select the PLANE function: Press the TILT
MACHINING PLANE soft key: The TNC displays the
available definition possibilities in the soft-key row
U Select the Reset function. This internally resets the
PLANE function, but does not change the current axis
positions
U Specify whether the TNC should automatically move
the rotary axes to the default setting (MOVE or TURN) or
not (STAY) (see “Automatic positioning:
MOVE/TURN/STAY (entry is mandatory)” on page
400)
U To terminate entry, press the END key
Example: NC block
25 PLANE RESET MOVE SET-UP50 F1000
The PLANE RESET function resets the current PLANE
function—or an active G80—completely (angles = 0 and
function is inactive). It does not need to be defined more
than once.
To Next Page
Loading...
Need help?
General
