HEIDENHAIN iTNC 530 19
1.1 Overview ..... 42
1.2 Machine Switch-On ..... 43
Acknowledge the power interruption and move to the reference points ..... 43
1.3 Programming the First Part ..... 44
Select the correct operating mode ..... 44
The most important TNC keys ..... 44
Create a new program/file management ..... 45
Define a workpiece blank ..... 46
Program layout ..... 47
Program a simple contour ..... 48
Create a cycle program ..... 50
1.4 Graphically Testing the Program ..... 52
Select the correct operating mode ..... 52
Select the tool table for the test run ..... 52
Choose the program you want to test ..... 53
Select the screen layout and the view ..... 53
Start the program test ..... 54
1.5 Tool Setup ..... 55
Select the correct operating mode ..... 55
Prepare and measure tools ..... 55
The tool table TOOL.T ..... 55
The pocket table TOOL_P.TCH ..... 56
1.6 Workpiece Setup ..... 57
Select the correct operating mode ..... 57
Clamp the workpiece ..... 57
Align the workpiece with a 3-D touch probe system ..... 58
Set the datum with a 3-D touch probe ..... 59
1.7 Running the First Program ..... 60
Select the correct operating mode ..... 60
Choose the program you want to run ..... 60
Start the program ..... 60
1 First Steps with the iTNC 530 ..... 41
To Next Page
Loading...
Need help?
General
