20
2.1 The iTNC 530 ..... 62
Programming: HEIDENHAIN conversational, smarT.NC and ISO formats ..... 62
Compatibility ..... 62
2.2 Visual Display Unit and Keyboard ..... 63
Visual display unit ..... 63
Sets the screen layout ..... 64
Operating panel ..... 65
2.3 Operating Modes ..... 66
Manual Operation and Electronic Handwheel ..... 66
Positioning with Manual Data Input ..... 66
Programming and Editing ..... 67
Test Run ..... 67
Program Run, Full Sequence and Program Run, Single Block ..... 68
2.4 Status Displays ..... 69
“General” status display ..... 69
Additional status displays ..... 71
2.5 Window Manager ..... 79
Soft-key row ..... 80
2.6 Accessories: HEIDENHAIN 3-D Touch Probes and Electronic Handwheels ..... 81
3-D touch probes ..... 81
HR electronic handwheels ..... 82
2 Introduction ..... 61
To Next Page
Loading...
