HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING User Manual

346 Programming: Special Functions
11.4 Tool Holder Management (DCM Software Option)
Removing a tool holder
U Delete the name of the tool holder from the KINEMATICS column in
the tool table (TOOL.T).
Danger of collision!
If you remove a tool holder, the TNC no longer monitors it,
even if it is still in the spindle

HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530 - 6-2010 DIN-ISO PROGRAMMING
Category	Control Panel
Language	English