New functions 606 42x-01 since the predecessor versions 340 49x-05
12
New functions 606 42x-01 since the
predecessor versions 340 49x-05
Opening and Editing of externally created files is new (see
“Additional tools for management of external file types” on page
121)
New functions in the task bar added (see “Soft-key row” on page
80)
Enhanced functions for configuration of the Ethernet interface (see
“Configuring the TNC” on page 547)
Improvements regarding Functional Safety FS (option):
General information on Functional Safety FS (see “General
Information” on page 456)
Explanation of terms (see “Explanation of terms” on page 457)
Checking the axis positions (see “Check axis positions” on page
458)
Activating feed-rate limitation (see “Activating feed-rate
limitation” on page 460)
Improvements regarding the general status views of a TNC with
functional safety (see “Additional Status displays” on page 460)
The new HR 510, HR 520 and HR 550 FS handwheels are supported
(see “Traversing with electronic handwheels” on page 444)
New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks)
3-D line graphics is now also possible in full-screen mode (see “3-D
Line Graphics (FCL2 Function)” on page 138)
A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see “Calling any
program as a subprogram” on page 240)
DCM: Saving and restoring of fixture situations
DCM: The form for test program generation now also contains icons
and tooltips (see “Check the position of the measured fixture” on
page 340)
DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired.(see “Operating
FixtureWizard” on page 337)
DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
DCM: A library with standard chucking equipment is available now
(see “Fixture templates” on page 336)
DCM: Tool carrier management (see “Tool Holder Management
(DCM Software Option)” on page 344)
To Next Page
Loading...
Need help?
General
