Heinzmann CargoPower - Transport and Handling of the Motor

2 Warnings and safety
CargoPower installation and operation, revision - 01 5
2.5 Transport and handling of the motor
In the event of temperature fluctuations or fluctuations in the ambient air pressure
(e.g. during air transport), a pressure equalization between the motor casing and
the environment happens. This can cause a negligible amount of oil to leak from
the motor. Therefore, always transport and store the motor upright, as in its
installation position, and do not leave it permanently in a lying position. During
transport the axle stub and torque support or alternatively the transport lock (see
following sketch) must be fitted.
Remove leaked oil according to the procedure for cleaning mineral or synthetic
oils.
After an oil leak, it is recommended to drain the motor oil completely and refill
the motor with fresh oil. Oil leakage does not limit the functionality of the motor
in the short term.
In connection with pressure equalization processes, oil can get into the plug
through the strands of the motor cable. This can cause a light film of oil to form
on the contacts of the plug. This oil film does not restrict the functionality of the
plug.
Always transport and store motors upright.
Correct
Incorrect
Torque support with axle stub or transport lock must be fitted.
Right,
with torque support
and stub axle
Right,
With transport lock
Incorrect