2 Warnings and safety
CargoPower installation and operation, revision - 01 3
2.3 General safety
Risk of breakage due to damaged or incorrectly mounted motor
A damaged or incorrectly mounted motor can cause load-bearing parts to
break! This may result in a fall!
˃ Do not undertake any further journeys
˃ Replace damaged motor immediately
˃ When fitting the drive wheel, tighten the wheel nuts to the specified
tightening torque!
Danger due to unforeseen motor activity and rotating parts
The motor may start moving unexpectedly if the drive system is left on
while working on the vehicle. Limbs or clothing may be drawn into
rotating parts. This can result in injuries.
˃ Remove the battery before any work on the vehicle.
˃ When putting the vehicle back into operation after assembly or
repair, position it so that the drive wheel can rotate freely. Only then
reinsert the battery and check the proper function of the drive.
Danger of burns from hot motor during operation!
˃ Do not touch surfaces of the drive system during and up to 30
minutes after use.
˃ If interventions are nevertheless unavoidable, wear suitable
protective gloves
Damaged electrical assemblies or cables can lead to short circuits! This
can result in fires!
˃ Replace damaged electrical assemblies or cables immediately
Due to unforeseen events or unauthorized use, the vehicle may start
moving unexpectedly! This may result in personal injury or damage to
property!
˃ Always switch off the drive system when parking and leaving the
vehicle
To Next Page
Loading...