Heinzmann CargoPower - Buttons for Further Functions; Button for Starting Aid or Reversing; Starting Aid Function; Reverse Function

4 Peripherals
CargoPower installation and operation, revision - 01 24
4.4 Buttons for further functions
The following functions can be used by fitting additional buttons:
• Starting aid
• Reverse
For these functions, the buttons used are identical in construction. To avoid confusion, the
plugs of both buttons are different depending on the function:
• Starting aid > Male plug
• Reverse > Female plug
4.4.1 Button for starting aid or reversing:
4.4.2 Starting aid function:
The starting aid may support up to 6 km/h (DIN EN 15194:2018-11) without having to
pedal.
There are two ways to activate the starting aid when the vehicle is stationary:
• With knob and throttle/thumb throttle:
Press the button for starting aid and at the same time press the thumb throttle/throttle
grip. This activates the starting aid.
• With brake contact and throttle/thumb throttle:
Pull the brake handle and at the same time press the thumb throttle/throttle grip. If
the brake is now released, the starting aid is activated.
4.4.3 Reverse function:
• With reverse button and throttle grip/thumb throttle:
Press the button for reverse and at the same time twist the grip throttle respectively
press the thumb throttle. This will activate the reverse drive.