Heinzmann CargoPower - Gear Selection and Transmission Ratio

5 System FREE DRIVE
CargoPower installation and operation, revision - 01 36
5.3.5 Gear selection and transmission ratio
The maximum number of possible gears (= transmission ratio) of the system is 10. This
number is configured by HEINZMANN.
- Briefly pressing button A = Shift up gear
- Briefly pressing button C = Shift down gear
After switching on, the system always assumes the following state:
- Gear = 0
- Support level = "Zero".
After briefly pressing
button A or C, the number of
LEDs corresponding to the gear number lights up on
the display bar for 1 second.
Afterwards, the support level and battery charge status
are displayed again.
If you shift down to gear = 0, the display bar
remains dark for
1 second. After that, the
support level and battery charge status are
displayed.
Unexpected behaviour of the vehicle
The vehicle can accelerate strongly and unexpectedly!
Gear = 0 does not mean that the transmission ratio is basically = 0!
˃ Before the first drive, check for safety reasons whether a
transmission ratio = 0 has been parameterised accordingly.
˃ If no gear ratio = 0 has been set, it is imperative that the driver is
informed that the vehicle can start even if the gear ratio = 0 has
been set.
A
B
C