3 Installation of the drive set
CargoPower installation and operation, revision - 01 12
3.2.3 Brake disks
Dirty brake disks lead to reduced braking power or complete failure of
the brakes! This can result in a fall!
˃ Always keep brake disks free of oil or lubricants
Suitable for the CargoPower motor RN111 motor are brake disks with the following
technical data:
at least Ø160 mm or larger
M6×0.5 (HEINZMANN special screw)
The threaded hole for the brake disk fastening screws must not be drilled
open or deeper. This can damage the motor housing and there is a risk
of oil leaking out.
For the installation of brake disks there is an instruction video from
HEINZMANN on the media portal YouTube.
It can be accessed at the following address:
• German-language:
https://www.youtube.com/watch?v=j2QrnWHL07g
• English-language:
https://www.youtube.com/watch?v=yXy39HSY3LI
To Next Page
Loading...