1 Safety instructions and symbols used for them
CargoPower installation and operation, revision - 01 1
1 Safety instructions and symbols used for them
In the following document, specific warnings are given to point out the unavoidable residual
risks when operating the machine. These residual risks imply dangers to
• People
• Product and machine
• Environment
The most important aim of the warnings is to prevent personal injury!
The signal words used in the print are primarily intended to draw attention to the possible extent
of damage!
DANGER indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if
not prevented, may result in minor injury.
NOTE indicates possible damage to property.
In addition to the signal word, safety instructions are also marked by
triangular warning symbols. In some cases, round command symbols
supplement the warnings. The symbols are intended to illustrate the danger
and the protective measure.
In any case, the symbols cannot replace the text of the safety notice. The
text must therefore always be read in full!
This symbol does not indicate safety instructions, but provides important
information for a better understanding of the functions. These should be
observed and adhered to without fail
To Next Page
Loading...