6 System settings and service software
CargoPower installation and operation, revision - 01 43
• Confirm the query after searching for a control unit. If further queries are made to
establish communication, confirm these as well.
• The green highlighted display "Online" in the lower left corner of the window
indicates the successful establishment of communication.
HEINZMANN recommends the connection via CAN described below
as this has advantages compared to a serial connection.
The access is located between the splitter 1 and the HMI interface, which is located in the
cockpit or on the handlebars of the vehicle.
A CAN-Y cable must be installed between splitter 1 and the HMI. This is available from
HEINZMANN under item no. 010-00-711-00.
To Next Page
Loading...