HellermannTyton Autotool 2000 CPK - 9 HT Data Management; First Steps; Access Levels; Binding Menu

Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
HT Data Management
17
9 HT Data Management
The HT Data Management software enables you to:
• Update the software for the power pack and
AT2000CPK.
• Export production data.
• Change parameters.
9.1 First steps
f Install the HT Data Management software on a PC.
f Switch on the AT2000 CPK, à"Switching on" on
page11.
In: Last Tie
Out: Error
Out: Busy
Serial port
1
f Connect the PC to the power pack with the provided
USB cable 1 .
f Launch the HT Data Management software.
; The HT Data Management start page appears on the
screen, à"Binding menu" on page18.
NOTE
When the AT2000 CPK is connected, error messages may be
displayed in the HTDM while binding if the settings of the
AT2000 CPK display have been changed.
9.2 Access levels
There are three access levels. Each level permits access
to the features available on the lower levels:
• Operator level
• Setup-specialist level
• Service level
9.2.1 Binding menu
Level Binding
information
Binding
parameters
Change
language
Synchronise
with PC time
Operator Read No Yes Yes
Setup
specialist
Read Yes Yes Yes
Service Yes Yes Yes Yes
9.2.2 Service menu
Level Change service pa-
rameter settings
Change para-
meter settings
Change
access code
Operator No No No
Setup
specialist
No Yes Yes
Service Yes Yes Yes
9.2.3 Memory menu
Level Export data Delete memory
Operator Yes No
Setup specialist Yes No
Service Yes Yes
9.2.4 Update menu
Level Perform
updates
Change
access code
Operator No No
Setup specialist Yes Yes
Service Yes Yes
9.2.5 Measurement environment menu
Level Visibility
Operator No
Setup specialist Yes
Service Yes
9.2.6 Parameter set menu
Level Create parameter sets
Operator No
Setup specialist Yes
Service Yes