HellermannTyton Autotool 2000 CPK - Change Password; Update Binding Parameters; Install Other Languages

Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
HT Data Management
24
There are separate *.HEX files for the AT2000 CPK and the
power pack:
AT2000 CPK: AT2000CPK_Tool_Vxxx
Power pack: AT2000CPK_PowerPack_Vxxx
f Select the appropriate *.HEX file.
f In the window opened by the operating system, click on
the Open button.
; The Start upload button appears on the screen.
f Click on Start upload.
; The new firmware is uploaded.
; The progress bar shows progress of the data transfer in
percent (%).
; The AT2000 CPK display shows the current data transfer.
NOTE
Do not interrupt the connection during the data transfer. In
the event of an interruption, the AT2000 CPK will become
unusable and will need to be sent back to the manufacturer.
9.6.2 Change password
The setup specialist's password consists of four characters
and the default setting is 0000. HellermannTyton
recommends setting an alphanumeric password that includes
at least one special character.
f Click on Change.
f Enter the current password and click on OK to confirm.
f Enter the new password and click on OK to confirm.
f Re-enter the new password and click on OK to confirm.
; The password is changed.
9.6.3 Update binding parameters
The update for the binding parameter settings
3 has the
file ending “.cpkparam”.
f Click on Load from file.
f Select the file.
f In the window opened by the operating system, click on
the Open button.
; The name of the file appears in File loaded.
f Click on Send to tool.
; The new binding parameters are transmitted to the
AT2000 CPK.
; The progress bar shows progress of the data transfer in
percent (%).
9.6.4 Install other languages
The update for languages which do not use Latin
characters, e.g. Asian languages, has the file ending
“.bin”.
f Click on Load from file.
f Select the file.
f In the window opened by the operating system, click on
the Open button.
; The name of the file appears in File loaded.
f Click on Send to tool.
; The new languages are transmitted to the AT2000 CPK.
; The progress bar shows progress of the data transfer in
percent (%).