HellermannTyton Autotool 2000 CPK - Changing Back-Up Battery; 11 Maintenance; Important Notes; Accessories and Extras

Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
Maintenance
34
5
f Turn the drum 5 past the point of indexing resistance
and remove the cable-tie residues.
f Close the left and right service flaps.
f Switch the power pack ON.
f Close the gate.
f Load a new cable tie bandoleer, à"Loading cable ties"
on page11.
10.4.2 Changing back-up battery
DANGER
A hazardous electrical current flows though the body
in direct or indirect contact with electrically live parts.
Electric shock, burns or death can result.
f Work on the electrical supply and on parts that are live
when the device is in operation should always be carried
out by a trained electrician.
f Use only OEM fuses of the specified amperage.
f Have faulty electrical components replaced immediately.
f Always disconnect the plug from the power-supply outlet
before starting maintenance work and troubleshooting.
f Check the electrical equipment of the device at regular
intervals. Have defects such as loose connections or
scorched wiring repaired immediately.
f Switch the power pack OFF.
f Disconnect the power cord from the power-supply
outlet.
Data Signal Power
Power pack CPK
2
1
1
f Remove the cover screws 1 .
f Remove housing
2 from the power pack.
3
f Change back-up battery 3 .
For details of battery type, à"PowerpackCPK" on
page38
f Position the housing 2 and ax using the cover
screws 1 .
f Set the date and time, à"Date / time" on page16.
11 Maintenance
11.1 Important notes
Regular servicing is essential in order to ensure that the
device remains in safe working order, à"Maintenance
schedule" on page35.
CAUTION
Crush hazard when jaws close.
f Do not insert fingers between upper and lower jaws and
do not keep your finger on the trigger.
f Always keep the power pack switched OFF while
maintenance is in progress.
CAUTION
Crush hazard due to moving/rotating parts when service flaps
are open.
f Do not insert fingers underneath the drum and do not
keep your finger on the trigger.
f Always keep the power pack switched OFF while
maintenance is in progress.
11.2 Accessories and extras
Accessories and extras can be ordered directly from your
national HellermannTyton representative, àseparate
spare parts list.
Name Article number
Power pack CPK 106-00100
Bench mount kit CPK 106-00040
Overhead suspension CPK 106-00050
CPK safety warnings 106-29003
Power cable, 1.8m 123-90040
Connecting cable, 2m 123-90052