HEX ezCAN - Page 30

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 30 of 60 ezCAN 2408.x
Adjusting Aux 2 lights
only
1. Press and hold the DOWN button until the Aux 2 lights
flash twice.
 The Aux 2 lights are now in brightness-adjustment
mode.
2. Briefly press and release the UP button to increase light
brightness by 10% per click (to a maximum of 100%), or
the DOWN button to decrease brightness by 10% per
click (to a minimum of 0%).
3. Exit brightness-adjustment mode by not operating the
UP or DOWN buttons for more than 5 seconds.
Toggling Aux 1 lights
On and Off
Press and hold the turn-signal cancel button for more than 3
seconds. The state of the lights persists even if the ignition is
cycled.
Toggling Aux 2 lights
On and Off
Click the turn-signal cancel button three times. The state of
the lights persists even if the ignition is cycled.
Temporarily switching
off all front and rear
auxiliary lights
Press and hold the turn-signal cancel button for more than 10
seconds.
If all front and rear auxiliary lights are temporarily switched
off, the ezCAN will turn the rear auxiliary lights back on:
 Whenever Aux 1 or Aux 2 lights are turned back on.
 After the ignition switch is cycled.
Strobing Aux lights on
‘Flash-to-pass’
Click the motorcycle’s ‘Flash-to-pass’ button three times.
Note that to be active, this function must be enabled using
the ezCAN configuration interface.
5.1.3.3 Controlling Aux 1 and Aux 2 lights on all other non-Gobi KTM models
For all KTM models other than 2021-onward 1290s, operation of ezCAN II
for KTM varies depending on whether an auxiliary light control switch is
installed. If an auxiliary light control switch is installed, ezCAN operation
also varies depending on switch type:
 To operate front auxiliary lights if no accessory switch is installed,
see If no aftermarket Aux light switch is installed.
 To operate front auxiliary lights if a Hex UP-DOWN switch is
installed, see If the Hex UP-DOWN switch is installed.
NOTES
If all front and rear auxiliary lights are temporarily switched
off (see table above), these lights will be switched back on
when the ignition is cycled.
Alternatively, Aux1 and/or Aux 2 lights can be switched
back on using the Toggling Aux 1/2 lights On and Off
functions (see table above).
When using the Toggling Aux 1/2 lights On and Off
functions, note that any rear auxiliary (Run/Brake) lights will
be switched back on whenever Aux 1 and/or Aux 2 lights
are switched back on.