HIKVISION DS-2SF8C442MXG-EL/26 - Page 42

Steps
1.
Go to VCA → Intell Trac Event → Common Sengs → Speed Dome Rule Sengs .
2.
Select Trac Event Detecon.
3.
Click Roadblock
Detecon and check Enable.
4.
Select Arm Lane or Arm Polygon.
Roadblock detecon takes eect in the selected lanes or areas.
5.
Set Sensivity.
With higher sensivity, the device is more sensive to detect and recognize targets.
6.
Set
Duraon.
When the roadblock stays in the detecon area longer than the duraon, an alarm is triggered.
7.
Set Filtering Time.
Within the set
ltering me, the roadblocks in the same detecon area will not trigger the alarm
repeatedly.
8.
Click Save.
What to do next
Set the arming schedule and linkage and alarm. See
Set ITS Arming Schedule and ITS Linkage and
Alarm for details.
Set
Construcon Detecon
The device detects ongoing construcon in the detecon area and captures pictures.
Before You Start
Set detecon areas. See Set Polygon Area and Set Lane Area for details.
Steps
1.
Go to VCA → Set
Applicaon → Tunnel Event Detecon → Panoramic Rule Sengs .
2.
Click Add Event and select Construcon Detecon.
3.
Select Arming Lane or Arming Polygon.
Construcon detecon takes eect in the selected lanes or areas.
4.
Set Sensivity.
With higher
sensivity, the device is more sensive to detect and recognize targets.
5.
Set Duraon.
When the
construcon in the detecon area lasts longer than the duraon, an alarm is
triggered.
6.
Set Filtering Time.
Within the set
ltering me, the construcon in the same detecon area will not trigger the
alarm repeatedly.
7.
Click Save.
TandemVu PTZ Camera User Manual
30