Network Video Recorder User Manual
92
8.3 Configure Advanced Settings
8.3.1 Configuring DDNS
You can set the Dynamic DNS (DDNS) for network access. Prior registration with your ISP is
required before configuring the system to use DDNS.
Steps
1. Go to Menu → Configuration → Network.
2. Select DDNS to enter the DDNS Settings interface.
3. Check Enable DDNS to enable this feature.
4. Select DDNS Type as DynDNS, PeanutHull, or NO-IP.
5. Configure Server Address,Device Domain Name,User Name,User Name.
6. Click Apply to save and exit the interface.
8.3.2 Configure NTP Server
A Network Time Protocol (NTP) Server can be configured on your NVR to ensure the accuracy of
system date/time.If the NVR is connected to a public network, you should use a NTP server that
has a time synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the NVR is setup in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.
Steps
1. Go to Menu → Configuration → Network → NTP.
2. Check Enable NTP.
3. Configure the following NTP settings.
Interval
Time interval between the two synchronizing actions with NTP server. The unit is minute.The
time synchronization interval can be set from1 to 10080min, and the default value is 60min.
NTP Server
IP address of NTP serve.r
NTP Port
Port of NTP server.
4. Click Apply.
8.3.3 Configure More Settings
Steps
1. Go to Menu → Configuration → Network.
To Next Page
Loading...
Need help?
General
