Video Access Control Terminal User Manual
29
2. You can editing the following parameters:
Enable Card Reader: Select Yes to enable the card reader.
OK LED Polarity: Select the OK LED Polarity of the card reader mainboard.
Error LED Polarity: Select the Error LED Polarity of the card reader mainboard
Buzzer Polarity: Select the Buzzer LED Polarity of the card reader mainboard
Interval between Card Swiping: If the interval between card swiping of the same card is less than the set
value, the card swiping is invalid. You can set it as 0 to 255.
Max. Interval When Inputting Password: When you inputting the password on the card reader, if the
interval between pressing two digits is larger than the set value, the digits you pressed before will be cleared
automatically.
Enable Failed Attempts Limit of Card Reading: Enable to report alarm when the card reading attempts reach
the set value.
Max. Times of Card Swiping Failure: Set the max. failure attempts of reading card.
Enable Tampering Detection: Enable the anti-tamper detection for the card reader.
Detect When Card Reader is Offline for: When the access control device cannot connect with the card
reader for longer than the set time, the card reader will turn offline automatically.
Mode: Select the card reader mode as normal mode (reading card) or issuing card mode (getting the card
No.).
3. Click the Save button to save parameters.
4. Click Apply Parameters button to apply the updated parameters to the local memory of the device.
Deleting Device
Steps:
1. In the device list, click to select a single device, or select multiple devices by pressing Ctrl button on your
keyboard and clicking them one by one.
2. Click Remove button to delete the selected device(s).
3. Click OK button in the pop-up confirmation dialog to finish deleting.
To Next Page
Loading...
