Video Access Control Terminal User Manual
86
7. Select the template of the authentication group from the dropdown list. For details about setting the
template, refer to 4.3 Schedule Template.
8. Select the authentication type of the authentication group from the dropdown list.
Local Authentication: Authentication by the access control device.
Local Authentication and Remotely Open Door: Authentication by the access control device and by the
client.
For Local Authentication and Remotely Open Door type, you can check the checkbox to enable the
super password authentication when the access control device is disconnected with the client.
Local Authentication and Super Password: Authentication by the access control device and by the
super password.
9. In the list on the left, the card group name will be displayed. You can click the card group and click Add to
add the group to the authentication group.
You can click the added card group and click Delete to remove it from the authentication group.
You can also click Up or Down to set the card swiping order.
10. Click Done to save the settings.
11. Click Apply Settings button to take effect of the new settings.
Notes:
For each access control point (door), up to four authentication groups can be added.
For the authentication group which certificate type is Local Authentication, up to 8 card groups can be
added to the authentication group.
For the authentication group which certificate type is Local Authentication and Super Password or Local
Authentication and Remotely Open Door, up to 7 card groups can be added to the authentication group.
Open Door with First Card
Purpose:
The door remains open for the configured time duration after the first card swiping until the remain open
duration ends.
Steps:
1. Click Open Door with First Card tab and select an access control device from the list on the left.
2. Check the checkbox of Enable First Card Remain Open to enable this function.
To Next Page
Loading...
