Fingerprint Access Control Terminal
19
Note: By default, the terminal selects Controller. Configure the Terminal Authentication in the
Access Control System module. For details, see Section 4.5.1 Configure Access Control
Parameters.
10. Select to enable/disable Duress Card function. When the function is enabled, the user linked card
will be a duress card. You are able to use the duress card to open the door and report a duress
event.
11. Press the ESC key and select Yes to save the settings and exit the interface.
4.4.2 Managing the User
4.4.2.1 Searching the User
Purpose:
Enter the user ID No. or the user name to search the target user.
Steps:
1. Enter the user ID or the user name in the searching bar of the user list interface,
2. Press the OK key to search.
User List Interface Figure 4. 32
4.4.2.2 Editing the User
Steps:
1. Select a target user in the user list and press the OK key.
2. Select Edit User in the User Configuration interface.
User Configuration interface Figure 4. 33
3. Follow Section 4.4.1 Adding User to edit the user information.
4. Press the ESC key and select Yes to save the settings and exit the interface.
Note: The user ID No. cannot be edited.
To Next Page
Loading...
