Fingerprint Access Control Terminal
11
Wi-Fi Selection Figure 4. 18
3. Select a network and press the OK key to enter the Wi-Fi Setting interface.
4. Input the Wi-Fi password, and configure the IP mode the IP address, the subnet mask and the
gateway.
Note: The password supports numbers, uppercase letters, lowercase letters and symbols.
Wi-Fi Setting Interface Figure 4. 19
5. Press the ESC key and select Yes to save the parameters and exit the interface.
4.3.2 System Settings
Purpose:
You are able to set the system parameters, manage the data, restore default parameters and upgrade
the device.
4.3.2.1 Setting System Parameters
Purpose:
Set the system parameters, including the device time format, the keypad audio, the voice prompt, the
voice volume, the sleeping, the attendance repeating time interval, the attendance record over
threshold prompt, the secure door control panel and the record delete.
To Next Page
Loading...
