Fingerprint Access Control Terminal
31
Man-hour Shift Configuration Interface Figure 4. 57
4. Select Edit to enter the Edit Shift interface.
You can edit the shift name, the shift duration, the latest time on-work and the break time.
Edit Shift Interface Figure 4. 58
Notes:
The shift No. cannot be edited.
The break time will not be counted into the working hour.
If set the Latest Time (On-Work) to 0, the function is disabled by default.
You can also select Reset and press the OK key to reset the settings.
5. Press the ESC key and select Yes to save the settings and exit the interface.
4.6.3 Configuring Holiday
Purpose:
Configure the attendance holiday. The device will not take attendance during the holiday.
4.6.3.1 Adding Holiday
Steps:
1. In the Holiday interface, press the key to enter the New (New Holiday) interface.
To Next Page
Loading...
