Fingerprint Access Control Terminal
12
System Configuration Interface Figure 4. 20
MM/DD/YYYY、MM.DD.YYYY、DD-MM-YYYY、DD/MM/YYYY、
DD.MM.YYYY、YYYYMMDD、YYYY-MM-DD、YYYY/MM/DD、
YYYY.MM.DD and MM-DD-YYYY are available.
Move the cursor to or and press the OK key to enable or
disable the keypad sound.
Move the cursor to or and press the OK key to enable or
disable the prompt audio.
Note: The icon represents the keypad sound is enabled. The
icon represents the keypad sound is disabled.
High, Medium and low can be selected.
Set the device sleeping waiting time (Minute). If you set the sleeping
time to 30min, the device will sleep after 30 min without any
operation.
Note: If you set the sleeping time to 0, the function is disabled.
Set the attendance repeating time interval (Second) of a person. The
attendance will be invalid, the authentication will be failed, and the
door will not be open if the user swipe the card repeatedly within
the time interval. (Set the authentication mode to Card).
Note: The time interval should be between 0 and 255s.
Attendance
Record Prompt:
If the attendance record memory reaches the configured value, the
system will pop up a prompt to remind you.
Secure Door
Control Panel:
Enable/disable the secure door control panel. The terminal connects
to the secure door control panel via the RS-485. And the terminal
will receive the magnetic signals, the door opening button signal and
To Next Page
Loading...
