Fingerprint Access Control Terminal
13
the input/output alarm signals via the secure door control panel.
When disabling the function, the terminal can control these signals
directly.
When enabling the function, the terminal will delete the first 3000
attendance records, if the memory is full, to save the new
attendance records. By default, the function is enabled. For detailed
information, see Section 6.2 Attendance Record Delete Rule.
4.3.2.2 Managing Data
Purpose:
You are able to delete the storage data of the device, including the event, the attendance data, the user,
and the permission.
Steps:
1. Move the cursor to Data and press the OK key to enter the Data interface.
2. Select a data type and press the OK key to delete.
Data Management Interface Figure 4. 21
Delete all recorded events in the device.
Delete Attendance
Data Only:
Delete all attendance data in the device or delete
attendance data by time.
Delete Attendance Data Interface Figure 4. 22
Delete all user data in the device, including the attendance
records.
Clear the admin management permission. The admin will
turn to the normal user. The user will not be deleted.
4.3.2.3 Restoring Settings
Purpose:
You can restore Factory Defaults or Default Settings.