Fingerprint Access Control Terminal
10
You are able to set the Wiegand Direction (Send/Receive) and the Wiegand mode (Wiegand 26/Wiegand
34).
Steps:
1. Move the cursor to Wiegand, and press the OK key to enter the Wieagand interface.
Wiegand Setting Interface Figure 4. 16
2. Edit the Wiegand parameters, including the Wiegand direction and the Wiegand mode.
Wiegand Direction:
If select “Send”, the terminal can connect to the access controller to upload the card No.
bia the Wiegand 26 or the Wiegand 34 mode.
If select “Receive”, the terminal can connect to the Wiegand card readers. No need to
configure the Wiegand mode. The default mode contains Wiegand 26/34 and the
Hikvision private Wiegand protocol.
Wiegand Mode:
Wiegand 26 and Wiegand 34 can be selected. The default Wiegand mode is Wiegand 34.
4.3.1.3 Setting Wi-Fi
Purpose:
You can enable the Wi-Fi and configure the Wi-Fi parameter.
Steps:
1. Move the cursor to Wi-Fi, and press the OK key to enter the Wi-Fi interface.
Wi-Fi Enabling Figure 4. 17
2. Move the cursor to the icon and press the OK key to enable the WLAN.
To Next Page
Loading...
