Fingerprint Access Control Terminal
79
Access Control Type
Purpose:
The added cards can be assigned with different card type for the corresponding usage.
Steps:
1. Click Access Control Type tab and select a card type.
Normal Card: By default, the card is set as normal card.
Card for Disabled Person: The door will remain open for the configured time period for the
cardholder.
Card in Blacklist: The card swiping action will be uploaded and the door cannot be opened.
Patrol Card: The card swiping action can used for checking the working status of the inspection staff.
The access permission of the inspection staff is configurable.
Duress Card: The card swiping action will be uploaded.
Super Card: The card is valid for all the doors of the controller during the configured schedule.
Visitor Card: The card is assigned for visitors.
2. Click Add and select the available card.
3. Click OK to confirm assigning the card(s) to the selected card type.
4. Click the Apply button to take effect of the new settings.
Notes:
You can click Delete to remove the card from the card type and the card can be available for
being re-assigned.
The attendance device only supports the normal card.
Card Reader Authentication
Purpose:
You can only open the door by both swiping card and entering the password during the set time periods.
Notes:
For this authentication mode, the card swiping operation cannot be replaced by entering the card
No.
For password settings, please refer to Section 5.3.2 Card Management.
Steps:
To Next Page
Loading...
