Fingerprint Access Control Terminal
81
Steps:
1. Click First Card and select an access control point.
2. Check the checkbox of Enable First Card Remain Open to enable this function.
3. In the Remain Open Duration (min), input the time duration for remaining open the door.
4. Click and select the cards to add as first card for the door and click the
button.
5. Click and then click to take effect of the new settings.
Note: The attendance device does not support the function.
Anti-Passing Back
Purpose:
In this mode, you can only pass the access control system according to the specified path.
Note: Either the anti-passing back or multi-door interlocking can be configured for an access controller
at the same time.
Setting the Path of Swiping Card (Card Reader Order)
Steps:
1. Click Anti-passing Back and select an access control point.
To Next Page
Loading...
