Note
●
7 zone types are supported: Emergency Switch, Door Magnec Switch, Smoke
Detector, Acve IR Detector, Passive IR Detector, Combusble Gas Detector, and
DoorBell Switch.
●
3 types of alarm mode are supported: Instant Alarm, 24H Alarm, and Delay
Alarm.
●
When the zone type is set to be Instant Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered. Under
disarming mode, it will not receive alarm message when the detector is
triggered.
●
When the zone type is set to be 24H Alarm, the indoor
staon will receive
alarm message when the detector is triggered no maer it is under arming
mode or disarming mode.
●
When the zone type is set to be Delay Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered. Under
disarming mode, it will not receive alarm message when the detector is
triggered.
●
Aer seng enter delay me, if OK is pressed within the enter delay me aer
the alarm, the alarm event will not be uploaded to the management center; if
OK is not pressed within the enter delay me aer the alarm, the alarm event
will be uploaded to the management center.
●
The exit delay is the me between you enable the arming mode and the arming
takes eect.
IP Camera Informaon
You can add, delete and modify cameras that can be added to the video intercom
products, with two ways of
geng stream: direct or URL. By exporng and imporng
the added device informaon, you can edit added devices parameters in batch.
Add Camera
Steps
1. Click IP Camera Informaon to enter IP camera informaon page.
Video Intercom 9 Series Indoor
Staon Conguraon Guide
46