HIKVISION DS-TCG406-E - Page 22

Figure 3-5 Set License Plate Recognion Parameters
2.
Set Country/Region according to the actual needs.
3.
Set the following parameters.
License Plate
Recognion
●
Select Forward when license plates of vehicles from the approaching direcon need to be
recognized.
●
Select Backward when license plates of vehicles from the leaving direcon need to be
recognized.
●
Select Bidirecon when license plates of vehicles from both the approaching direcon and
the leaving direcon need to be recognized.
Fake Plate Filter
Aer you enable this funcon, if it is idened as a fake license plate, the device will not
output the captured picture and license plate
informaon, and the barrier gate will not be
opened.
4.
Click Save.
Set Supplement Light Parameters
Supplement light can enhance the image stabilizaon and adjust the brightness and color
temperature. It can supplement light at night or when the light is dim.
Steps
Note
Only when the constant light is connected, can the set parameters take eect.
1.
Go to Conguraon → Capture → Capture Parameters → Supplement Light Parameters .
Intelligent Entrance ANPR Camera User Manual
14