HIKVISION DS-TCG406-E - Page 23

Figure 3-6 Set Supplement Light Parameters
2.
Select I/O Output Mode as Constant Light Mode.
3.
Set the supplement light parameters according to actual
condions.
Enable Mode
Default
The default status of the supplement light depends on the device models.
Time Schedule
Select it when you want the constant light to be enabled during
xed me period. Set the
start me and end me.
Environment Brightness
Select it when you want the constant light to be controlled by detecng the surroundings
brightness automacally. Set the brightness threshold. The higher the threshold is, the
harder the constant light can be enabled.
White Light Brightness/IR Light Brightness
Drag the slider to adjust the brightness, or enter the value in the text
eld. The higher the
brightness is, the more the light will be supplemented.
Note
The actual funcons may vary with dierent models. The actual device prevails.
4.
Click Save.
Set Vehicle Feature Parameters
Set vehicle feature parameters when you need to capture the passing vehicle according to the
vehicle features.
Steps
Note
Some models do not support vehicle features recognion. The actual device prevails.
Intelligent Entrance ANPR Camera User Manual
15