Specifications
50 Affinity® 4 Birthing Bed Instructions for Use (USR025 REV 13)
Warning—Portable RF communications equipment (including peripherals such as antenna cables and
external antennas) should be used no closer than 30 cm (12 inches) to any part of the P3700 Affinity® 4
Birthing bed, including cables specified by the manufacturer. Equipment performance may be
impacted.
The use of accessories, transducers, and cables other than those specified, with the exception of
transducers and cables sold by the manufacturer of this device as replacement parts for internal
components, may result in increased emissions or decreased Immunity of the P3700 bed.
Medical electrical equipment needs special precautions in regard to electromagnetic compatibility
(EMC) and needs to be installed and put into service according to the EMC information supplied in the
following tables.
Guidance and Manufacturer's Declaration—Electromagnetic Emissions
The P3700 Affinity® 4 Birthing Bed is intended for use in the electromagnetic environment specified below. The
customer or the user should make sure that they are used in such an environment.
Emissions Test Compliance Electromagnetic Environment—Guidance
RF Emissions
CISPR 11
Group 1 The P3700 Affinity® 4 Birthing Bed uses RF energy only for its inter-
nal functions. Therefore, the RF emissions are low and are not
likely to cause any interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The P3700 Affinity® 4 Birthing Bed is suitable for use in all estab-
lishments, other than domestic establishments and those directly
connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
