Hioki 3802-50 - Continuity Check

2.5 Continuity Check
25
1
2
3
4
5
6
7
8
9
10
11
Measurement
2.5 Continuity Check
Never apply voltage to the test leads. Doing so may
damage the instrument and result in personal injury.
To avoid electrical accidents, remove power from
the circuit before measuring.
1. Set the function switch.
2. Select with the SHIFT key.
3. If you want to change the rang
e,
press the RANGE key.
(Normally, manual range is used.)
To change to auto range, hold th
e
RANGE key down.
❖ (34 page)
4. Connect the test leads to the test te
r-
minals.
5. Connect the test leads to the obje
ct
being tested.
6. Read the value displayed in th
e
main display.
In each range, the buzzer sounds when th
e
count is less than 1000 (less than 10.00 Ω
in the 510.00 Ω range).
However, in relative value display mode,
this conforms with the internally measure
d
value, not the display value.
Black
Red
<Example>
SHIFT
Black
Red
RANGE
(AUTO off)
( lights)