Hioki 3802-50 - Pulse Width Measurement

30
2.10 Pulse Width Measurement
2.10 Pulse Width Measurement
1.
Set the function switch.
❖ See Section 2.2 Voltage Measureme
nt
(page 19)
❖See Section 2.3 Current Measurement (pag
e
21)
2. Use the SHIFT key to select either D
C
or AC.
3. Use the Hz key to select the Puls
e
width.
4. If you want to change the rang
e,
press the RANGE key.
(Normally, manual range is used.)
❖ (34 page)
5. Connect the test leads to the test te
r-
minals.
6. Read the value displayed in the mai
n
display.
To switch the pulse slope polarity ,
hold down the SHIFT key.
SHIFT
Hz
<Example>
When measuring AC voltage
(ms lights)
RANGE
(AUTO off)
AC DC
The bar graph conforms with voltage measurement or
current measurement.