44
3.7 Communications Function
4. Connect the optical connector of the communications
cable to the connector on the holster for the 3802-50.
Communication is not possible if "RS-232C INTERFACE"
is facing downwards.
5. Connect the other end of the communications cable
to the personal computer.
6. Start the software. The measurement data is trans-
ferred from the 3802-50 to the personal computer.
Make sure "RS-232C INTERFACE
is facing upwards
To disconnect the connector from the 3802-50,
squeeze the clips while pulling the connector out.
Clip
To Next Page
Loading...
