Hirschmann BAT54-F Series User Manual

LANtools network management
180
5.2 Project management with LANconfig
BAT54-Rail/F..
Release 7.54 06/08
U Configuring the behavior of LANconfig at startup
The following parameters are used to configure the startup behavior of
LANconfig:
D Windows system startup
D Start LANconfig never: LANconfig does not start automatically with the
operating system, and it has to be started manually.
D Start LANconfig always: LANconfig always starts automatically after
Windows starts successfully.
D Start LANconfig like last time: LANconfig starts in the program in the
same status as when Windows was shut down the last time: If
LANconfig was active then it will be started again; if inactive,
LANconfig will not be automatically restarted.
Note: When changing to a setting that enables LANconfig to be started au-
tomatically, an change is made to the operating system's registry. Person-
al firewalls on the computer or the operating system itself (Windows XP
or Windows Vista
TM
) may interpret this change as an attack and may is-
sue a warning or even prevent the entry from being made. In order for
LANconfig's startup behavior to be controlled as desired, you can ignore
these warnings and allow the changes to be made.
Configuration tool Call
LANconfig Options
 Extras  Application

Hirschmann BAT54-F Series Specifications

General

Brand	Hirschmann
Model	BAT54-F Series
Category	Wireless Access Point
Language	English