Hirschmann BAT54-F Series User Manual

Diagnosis
230
6.2 SYSLOG storage in the device
BAT54-Rail/F..
Release 7.54 06/08
6.2.1 Activate SYSLOG module
The SYSLOG module must first be activated for the protocol to be recorded.
Additionally an appropriate SYSLOG client must be configured (’Configuring
the SYSLOG client’ → page 230).
LANconfig
For configuration with LANconfig you will find the SYSLOG module under the
configuration area 'Log & Trace' on the 'SYSLOG' tab.
WEBconfig, Telnet or terminal program
Under WEBconfig, Telnet or a terminal program, you will find the SYSLOG
module under the following paths:
6.2.2 Configuring the SYSLOG client
The SYSLOG module can write different messages to the memory in the de-
vice. If there are messages that you do not require (e.g. debug and informa-
tion messages), you can reduce the scope of the messages by entering a
local loopback address of you BAT device in the IP area 127.x.x.x (e.g.
127.0.0.1) as the SYSLOG client; for this client, you then activate only certain
sources and/ or priorities.
LANconfig
For configuration with LANconfig you can open the list of SYSLOG clients un-
der the configuration area 'Log & Trace' on the 'SYSLOG' tab using the SYS-
LOG clients button.
Configuration tool Call/Table
WEBconfig Expert-Configuration
 Setup  SYSLOG
Terminal/Telnet
/Setup/SYSLOG

Hirschmann BAT54-F Series Specifications

General

Brand	Hirschmann
Model	BAT54-F Series
Category	Wireless Access Point
Language	English